Smart Array P440 Controller Mini-Sas Y-Cable Option For Rear Drive Cage; Install The Smart Array P440 Controller Mini-Sas Y-Cable For A Rear Drive Cage Option - HP Apollo 4200 Gen9 User Manual

e. Connect the Mini-SAS cable to the rear drive backplane and the HBA.
f. Position the Mini-SAS cable on top of the air baffle.
12. Install the access panel.
13. Install the server into the rack.
14. Power up the server.

Smart Array P440 Controller Mini-SAS Y-cable option for rear drive cage

This section describes how to connect an existing four-bay LFF or two-bay SFF hot-plug rear drive cage to a
Smart Array P440 controller using this Mini-SAS Y-cable option.

Install the Smart Array P440 Controller Mini-SAS Y-cable for a rear drive cage option

Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack.
4. Remove the access panel.
5. Remove the air baffle.
6. If you are installing the P440 controller for the four-bay LFF hot-plug rear drive cage, do one of the
following:
• Disconnect the Mini-SAS cable connected to the front drive cage 2 backplane from the rear drive
backplane.
92 Smart Array P440 Controller Mini-SAS Y-cable option for rear drive cage