Drive Cable Options; Mini-Sas Y-Cable Option For 8-Bay Lff Hot-Plug Drive Configurations - HP ProLiant DL180 Gen9 User Manual

Secure the Mini-SAS cable in the right front chassis cable clip.
g.
Install the access panel (on page 26).
19.
If removed, install the security bezel
20.
Do one of the following:
21.
Slide the server into the rack.
o
Install the server into the rack
o
Power up the server (on page 20).
22.
Install the drives
23.

Drive cable options

Use these drive cable options to install an HP Host Bus Adapter or an HP Smart Array Controller board
option.
For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP website (http://www.hp.com/go/qs).
Mini-SAS Y-cable option for 8-bay LFF hot-plug drive
configurations
This section explains how to connect the 620-mm Mini-SAS Y-cable option to upgrade the 8-bay LFF hot-plug
drive connection from the onboard storage controller or from an HBA to an HP Smart Array P-series
Controller.
To connect the cable option:
Power down the server (on page 20).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
("Security bezel
("Installing the server into the
("Drive options" on page 43).
option" on page 43).
rack" on page 36).
Hardware options installation 59