Installing An Ssd Module On The M.2 Ssd Enablement Board - HP Apollo 4200 Gen9 User Manual

d. Install the PCI riser cage.
e. Open the cable management holder.
f. Connect the SATA cables to the M.2 SSD enablement board and the system board.
g. Close the cable management holder.
h. Secure the extra length of the SATA cables in the cable management holder.
8. Install the air baffle.
9. Install the access panel.
10. Install the server into the rack.
11. Power up the server.
To manage and monitor the SSD modules, use Smart Storage Administrator.

Installing an SSD module on the M.2 SSD enablement board

Procedure
1. Power down the server.
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
2. Remove all power:
3. Remove the server from the rack.
4. Remove the access panel.
5. Remove the air baffle.
Installing an SSD module on the M.2 SSD enablement board 109