Connect The Mini-Sas X4 Cable Marked As Mlb; Install The H240 Hba And Its Mini-Sas X4 Cables - HP Apollo 4200 Gen9 User Manual

Connect the Mini-SAS x4 cable marked as MLB

In this storage cabling option, the rear SFF drives are managed by the onboard Dynamic Smart Array B140i
Controller. Both the multiconnector drive signal cable and the Mini-SAS x4 cable below will be in use.
Procedure
1. Remove the plastic connector covers from the Mini-SAS x4 cable.
2. Connect the Mini-SAS x4 cable to port 1 of the rear drive backplane.
3. Connect the other end of the cable to the system board.
4. Secure the cable in the rear drive cage cable clip.

Install the H240 HBA and its Mini-SAS x4 cables

In the six-bay SFF rear drive configuration, the H240 HBA is supported in the low-profile PCIe expansion slots
1, 2, 5, 6, and 7.
Procedure
1. Remove the air scoop from the HBA.
80 Connect the Mini-SAS x4 cable marked as MLB