HP Apollo 4200 Gen9 User Manual page 78

18. If you are NOT installing an H240 HBA or a P440 controller for the six-bay SFF rear drive cage, connect
the multiconnector drive signal cable:
a. Connect the common end of the multiconnector drive signal cable to port 2 of the rear drive
backplane.
b. Connect the split ends of the multiconnector drive signal cable to the system board.
c. Secure the cable in the rear drive cage cable clip.
d. Close the cable management holder.
19. Depending on which storage controller you prefer to use for managing the rear drives, perform one of the
succeeding storage cabling option procedures.
• Connect the preinstalled Mini-SAS x4 cable.
• Connect the Mini-SAS x4 cable marked as MLB.
• Install the H240 HBA and its Mini-SAS x4 cables.
• Install the P440 controller and its Mini-SAS Y-cable.
20. Install the air baffle.
21. Install the access panel.
22. Install the server into the rack.
23. Hewlett Packard Enterprise recommends installing at least one drive in the rear drive cage.
78 Hardware options installation