Drive Cable Options; Mini-Sas Y-Cable Option For 8-Bay Lff Hot-Plug Drive Configurations - HP ProLiant DL180 Gen9 User Manual

Secure the Mini-SAS cable in the right front chassis cable clip.
g.
Install the access panel (on page 25).
19.
If removed, install the security bezel
20.
Do one of the following:
21.
Slide the server into the rack.
o
Install the server into the rack
o
Power up the server (on page 20).
22.
Install the drives
23.

Drive cable options

Use these drive cable options to install a Host Bus Adapter or a Smart Array Controller board option.
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
Mini-SAS Y-cable option for 8-bay LFF hot-plug drive
configurations
This section explains how to connect the 620-mm Mini-SAS Y-cable option to upgrade the 8-bay LFF
hot-plug drive connection from the onboard storage controller or from an HBA to an Smart Array P-series
Controller.
To connect the cable option:
Power down the server (on page 20).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Do one of the following:
3.
Extend the server from the rack (on page 20).
o
Remove the server from the rack (on page 22).
o
Remove the access panel (on page 24).
4.
("Security bezel
("Installing the server into the
("Drive options" on page 41).
option" on page 41).
rack" on page 35).
Hardware options installation 56