Dual 8Gb Microsd Enterprise Midline Usb Device; Redundant Power Supply Option - HP Apollo 4200 Gen9 User Manual

To enable the dedicated iLO management module:
1. During the server startup sequence after installing the module, press F9 in the POST screen.
The System Utilities screen appears.
2. Select System Configuration | iLO 4 Configuration Utility.
The iLO 4 Configuration Utility screen appears.
3. Select Network Options, and then press Enter.
The Network Options screen appears.
4. Set the Network Interface Adapter field to ON, and then press Enter.
5. Press F10 to save your changes.
A message prompt to confirm the iLO settings reset appears.
6. Press Enter to reboot the iLO settings.
7. Press Esc until the main menu is displayed.
8. Select Reboot the System to exit the utility and resume the boot process.
The IP address of the enabled dedicated iLO connector appears on the POST screen on the subsequent
boot-up. Access the Network Options screen again to view this IP address for later reference.

Dual 8Gb microSD Enterprise Midline USB device

This server supports the installation of the Dual 8Gb microSD Enterprise Midline USB device on the server
internal USB connector.
This USB storage device contains a dual-SD card module that supports up to two SD, SDHC, or SDXC
storage cards providing data redundancy through a mirrored RAID-1 configuration. This USB storage device
connects to an internal USB connector and is configured upon boot.
To locate the internal USB connector, see "System board components." For more information, see the Dual
8Gb microSD EM USB storage device documentation on the Hewlett Packard Enterprise website.

Redundant power supply option

Install a second power input module to improve power efficiency and enable power redundancy.
WARNING:
To reduce the risk of electric shock or damage to the equipment:
• Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
• Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all times.
• Unplug the power cord from the power supply to disconnect power to the equipment.
• Do not route the power cord where it can be walked on or pinched by items placed against it. Pay
particular attention to the plug, electrical outlet, and the point where the cord extends from the
equipment.
WARNING:
To reduce the risk of injury from electric shock hazards, do not open power supplies. Refer all
maintenance, upgrades, and servicing to qualified personnel.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives, power input modules, and the
internal system components to cool before touching them.
132 Dual 8Gb microSD Enterprise Midline USB device