Table of Contents
Advertisement
CA-200
(4) w: Tare weight (g)
Input tare (sampler) weight. If the item is "0" or blank, "W" is net sample weight.
If it is not inputted by the end of measurement, input is waited.
Up to 9 characters can be inputted.
Example: 9.8765g
w: [9] key + [.] key + [8] key +[7] key + [6] key + [5] key+ [Enter] ke
(5) L: Liquid sample volume (ml)
Use it at sampling of constant volume (ml) of liquid sample.
Multiply the constant volume by the specific gravity.
Example: 5ml
L: [5] key+ [Enter] key
(6) S: Specific gravity of liquid sample
Input the specific gravity of liquid samples.
Example: 0.985
S: [0] key + [.] key + [9] key +[8] key + [5] key+ [Enter] key
(7) G: Gaseous sample volume (L)
Input the volume of the gaseous samples (L). Measurement results are indicated by the
concentration of volume/volume (V/V).
Example: 2.3 L
G: [2] key + [.] key + [3] key + [Enter] key
(8) t: Gaseous sample temperature (℃)
Correct gaseous sample temperature.
Example: 23 C
t: [2] key + [3] key + [Enter] key
(9) B: Blank value
When the number of times of measurements specified in "Blank Test" is completed,
the average (μg) of the blank measurement is inputted automatically.
If abnormal values are found, input values again.
(10) X: Optional coefficient X
Optional coefficient X can be used in concentration calculation formulas (2 or 7) or optional
calculation formulas (10 or 11).
Example: 10
X: [1] key + [0] key + [Enter] key
Section 5: Moisture Measurement Mode
5-15
y
Advertisement
Table of Contents
