Using Ftp To Access The Mib Files - Cisco Catalyst 2975 Software Configuration Manual

Appendix A Supported MIBs
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
You can also use this URL for a list of supported MIBs for the Catalyst 2975 switch:
Note
ftp://ftp.cisco.com/pub/mibs/supportlists/cat2975/cat2975-supportlist.html
You can access other information about MIBs and Cisco products on the Cisco web site:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml

Using FTP to Access the MIB Files

You can get each MIB file by using this procedure:
Make sure that your FTP client is in passive mode.
Step 1
Note
Use FTP to access the server ftp.cisco.com.
Step 2
Step 3 Log in with the username anonymous.
Step 4 Enter your e-mail username when prompted for the password.
Step 5 At the
Use the get MIB_filename command to obtain a copy of the MIB file.
Step 6
OL-19720-02
OLD-CISCO-CHASSIS-MIB (Partial support; some objects reflect only the stack master.)
OLD-CISCO-FLASH-MIB (Supports only the stack master. Use CISCO-FLASH_MIB.)
OLD-CISCO-INTERFACES-MIB
OLD-CISCO-IP-MIB
OLD-CISCO-SYS-MIB
OLD-CISCO-TCP-MIB
OLD-CISCO-TS-MIB
RFC1213-MIB (Functionality is as per the agent capabilities specified in the
CISCO-RFC1213-CAPABILITY.my.)
RMON-MIB
RMON2-MIB
SNMP-FRAMEWORK-MIB
SNMP-MPD-MIB
SNMP-NOTIFICATION-MIB
SNMP-TARGET-MIB
SNMPv2-MIB
TCP-MIB
UDP-MIB
Some FTP clients do not support passive mode.
prompt, change directories to /pub/mibs/v1 and /pub/mibs/v2.
ftp>
Using FTP to Access the MIB Files
Catalyst 2975 Switch Software Configuration Guide
A-3