Using Ftp To Access The Mib Files - Cisco 2950 - Catalyst Switch Configuration Manual

Appendix A Supported MIBs
Note The IF-MIB and the CISCO-IETF-VDSL-LINE-MIB are supported as read-only MIBs for the Fast
Ethernet interfaces on the CPE devices.

Using FTP to Access the MIB Files

You can obtain each MIB file by using this procedure:
Use FTP to access the server ftp.cisco.com.
Step 1
Log in with the username anonymous.
Step 2
Step 3 Enter your e-mail username when prompted for the password.
Step 4 At the
Step 5 Use the get MIB_filename command to obtain a copy of the MIB file.
You can also access information about MIBs on the Cisco website:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
78-11380-10
prompt, change directories to /pub/mibs/v1 and the /pub/mibs/v2.
ftp>
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Using FTP to Access the MIB Files
A-3