Configuring Flex Links And The Mac Address-Table Move Update - Cisco Catalyst 2975 Software Configuration Manual

Chapter 19 Configuring Flex Links and the MAC Address-Table Move Update Feature
Switch A does not need to wait for the MAC address-table update. The switch detects a failure on port 1
and immediately starts forwarding server traffic from port 2, the new forwarding port. This change
occurs in 100 milliseconds (ms). The PC is directly connected to switch A, and the connection status
does not change. Switch A does not need to update the PC entry in the MAC address table.
Figure 19-3
Switch B
Configuring Flex Links and the MAC Address-Table Move
Update
These sections contain this information:
•
•
•
•
•
OL-19720-02
MAC Address-Table Move Update Example
Switch C
Port 3
Port 1
Switch A
Default Configuration, page 19-8
Configuration Guidelines, page 19-8
Configuring Flex Links, page 19-9
Configuring VLAN Load Balancing on Flex Links, page 19-11
Configuring the MAC Address-Table Move Update Feature, page 19-12

Configuring Flex Links and the MAC Address-Table Move Update

Server
Port 4
Switch D
Port 2
PC
Catalyst 2975 Switch Software Configuration Guide
19-7