Configuring Dhcp Auto-Image Update (Configuration File And Image) - Cisco Catalyst 2975 Software Configuration Manual

Chapter 3 Assigning the Switch IP Address and Default Gateway
Switch(config-if)# no switchport
Switch(config-if)# ip address 10.10.10.1 255.255.255.0
Switch(config-if)# end

Configuring DHCP Auto-Image Update (Configuration File and Image)

Beginning in privileged EXEC mode, follow these steps to configure DHCP autoconfiguration to
configure TFTP and DHCP settings on a new switch to download a new image and a new configuration
file.
Before following the steps in this table, you must create a text file (for example, autoinstall_dhcp) that
Note
will be uploaded to the switch. In the text file, put the name of the image that you want to download.
This image must be a tar and not a bin file.
Command
Step 1
configure terminal
Step 2 ip dhcp pool name
Step 3 bootfile filename
Step 4 network network-number mask
prefix-length
Step 5 default-router address
Step 6 option 150 address
Step 7 option 125 hex
Step 8
copy tftp flash filename.txt
Step 9 copy tftp flash imagename.tar
Step 10 exit
Step 11 tftp-server flash:config.text
Step 12
tftp-server flash:imagename.tar
Step 13 tftp-server flash:filename.txt
Step 14 interface interface-id
Step 15 no switchport
Step 16
ip address address mask
Step 17 end
Step 18 copy running-config startup-config
OL-19720-02
Purpose
Enter global configuration mode.
Create a name for the DHCP server address pool and enter DHCP pool
configuration mode.
Specify the name of the file that is used as a boot image.
Specify the subnet network number and mask of the DHCP address pool.
The prefix length specifies the number of bits that comprise the
Note
address prefix. The prefix is an alternative way of specifying the
network mask of the client. The prefix length must be preceded
by a forward slash (/).
Specify the IP address of the default router for a DHCP client.
Specify the IP address of the TFTP server.
Specify the path to the text file that describes the path to the image file.
Upload the text file to the switch.
Upload the tar file for the new image to the switch.
Return to global configuration mode.
Specify the Cisco IOS configuration file on the TFTP server.
Specify the image name on the TFTP server.
Specify the text file that contains the name of the image file to download
Specify the address of the client that will receive the configuration file.
Put the interface into Layer 3 mode.
Specify the IP address and mask for the interface.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
Catalyst 2975 Switch Software Configuration Guide
Assigning Switch Information
3-13