Cisco Catalyst 2975 Software Configuration Manual page 574

Configuring MVR
Command
Step 5
mvr vlan vlan-id group [ip-address] (Optional) Statically configure a port to receive multicast traffic sent to the
Step 6
mvr immediate
Step 7 end
Step 8
show mvr
show mvr interface
or
show mvr members
Step 9
copy running-config startup-config (Optional) Save your entries in the configuration file.
To return the interface to its default settings, use the no mvr [type | immediate | vlan vlan-id | group]
interface configuration commands.
This example shows how to configure a port as a receiver port, statically configure the port to receive
multicast traffic sent to the multicast group address, configure Immediate Leave on the port, and verify
the results.
Switch(config)# mvr
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# mvr type receiver
Switch(config-if)# mvr vlan 22 group 228.1.23.4
Switch(config-if)# mvr immediate
Switch(config)# end
Switch# show mvr interface
Port
----
Gi1/0/2 RECEIVER
Catalyst 2975 Switch Software Configuration Guide
22-22
Purpose
multicast VLAN and the IP multicast address. A port statically configured as
a member of a group remains a member of the group until statically removed.
In compatible mode, this command applies to only receiver ports. In
Note
dynamic mode, it applies to receiver ports and source ports.
Receiver ports can also dynamically join multicast groups by using IGMP
join and leave messages.
(Optional) Enable the Immediate-Leave feature of MVR on the port.
Note This command applies to only receiver ports and should only be
enabled on receiver ports to which a single receiver device is
connected.
Return to privileged EXEC mode.
Verify the configuration.
Type Status
---- -------
ACTIVE/DOWN
Chapter 22
Immediate Leave
---------------
ENABLED
Configuring IGMP Snooping and MVR
OL-19720-02