Appendix A
Supported MIBs
The IF-MIB and the CISCO-IETF-VDSL-LINE-MIB are supported as read-only MIBs for the Fast
Note
Ethernet interfaces on the CPE devices.
Using FTP to Access the MIB Files
You can get each MIB file by using this procedure:
Make sure that your FTP client is in passive mode.
Step 1
Note
Use FTP to access the server ftp.cisco.com.
Step 2
Log in with the username anonymous.
Step 3
Step 4
Enter your e-mail username when prompted for the password.
At the
Step 5
Use the get MIB_filename command to obtain a copy of the MIB file.
Step 6
You can also access information about MIBs on the Cisco website:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
78-11380-12
Some FTP clients do not support passive mode.
prompt, change directories to /pub/mibs/v1 and the /pub/mibs/v2.
ftp>
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Using FTP to Access the MIB Files
A-3