Unsupported Commands in
Cisco IOS Release 12.2(55)SE
This appendix lists some of the command-line interface (CLI) commands that appear when you enter the
question mark (?) at the Catalyst 2975 switch prompt but are not supported in this release, either because
they are not tested or because of switch hardware limitations. This is not a complete list. These
unsupported commands are listed by software feature and command mode:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Access Control Lists
Unsupported Privileged EXEC Commands
access-enable [host] [timeout minutes]
access-template [access-list-number | name] [dynamic-name] [source] [destination] [timeout minutes]
clear access-template [access-list-number | name] [dynamic-name] [source] [destination].
OL-19720-02
Access Control Lists, page C-1
Boot Loader Commands, page C-2
Debug Commands, page C-2
IGMP Snooping Commands, page C-2
Interface Commands, page C-3
MAC Address Commands, page C-3
Miscellaneous, page C-4
Network Address Translation (NAT) Commands, page C-4
QoS, page C-5
RADIUS, page C-5
SNMP, page C-5
SNMPv3, page C-6
Spanning Tree, page C-6
VLAN, page C-6
VTP, page C-7
A P P E N D I X
Catalyst 2975 Switch Software Configuration Guide
C
C-1