Provisioning A New Member For A Stack; Setting The Member Priority Value - Cisco Catalyst 2975 Software Configuration Manual

Configuring the Switch Stack
Beginning in privileged EXEC mode, follow these steps to assign a member number to a member. This
procedure is optional.
Command
Step 1 configure terminal
Step 2
switch current-stack-member-number
renumber new-stack-member-number
Step 3 end
Step 4
reload slot stack-member-number
Step 5 show switch
Step 6 copy running-config startup-config

Setting the Member Priority Value

This task is available only from the master.
Note
Beginning in privileged EXEC mode, follow these steps to assign a priority value to a member: This
procedure is optional.
Command
Step 1
configure terminal
Step 2 switch stack-member-number priority
new-priority-number
Step 3
end
Step 4 reload slot stack-member-number
Step 5 show switch stack-member-number
Step 6
copy running-config startup-config
You can also set the SWITCH_PRIORITY environment variable. For more information, see the
"Controlling Environment Variables" section on page

Provisioning a New Member for a Stack

Note This task is available only from the master.
Catalyst 2975 Switch Software Configuration Guide
6-20
Purpose
Enter global configuration mode.
Specify the current member number and the new member number for the
member. The range is 1 to 9.
You can display the current member number by using the show switch
user EXEC command.
Return to privileged EXEC mode.
Reset the stack member.
Verify the stack member number.
Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the member number and the new priority for the member. The
member number range is 1 to 9. The priority value range is 1 to 15.
You can display the current priority value by using the show switch user
EXEC command.
The new priority value takes effect immediately but does not affect the
current master until the current master or the stack resets.
Return to privileged EXEC mode.
Reset the member, and apply this configuration.
Verify the member priority value.
(Optional) Save your entries in the configuration file.
3-21.
Chapter 6 Managing Switch Stacks
OL-19720-02