Drive System Maintenance; Checking The Seat Belt; Checking The Rollover-Protection-System (Rops) Knobs - Toro TITAN HD 1500 Operator's Manual

Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.
Checking the
Rollover-Protection-System
(ROPS) Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover, keep
the roll bar in the fully raised, locked position
and use the seat belt.
Ensure that the seat is secured to the
machine.
•
Check that both the mounting hardware and the
knobs are in good working condition.
•
Make sure that the knobs are fully engaged with
the ROPS in the raised position.
Note:
The upper hoop of the roll bar may need
to be pushed forward or pulled rearward to fully
engage both knobs (Figure 77 and Figure 78).
1. Roll bar in the upright
position
2. ROPS knob in the latched
position
3. Pull the ROPS knob out
and rotate it 90 degrees.
1. Engaged
59
Figure 77
4. Rotate the ROPS knob 90
degrees.
5. ROPS knob in the
unlatched position
6. Roll bar in the folded
position
Figure 78
2. Partially engaged—do not
operate with the ROPS in
this position.
g036746
g034593