Toro TITAN HD 1500 Operator's Manual page 68

Note:
The switch is a part of the seat assembly.
4. Temporarily install a jumper wire across the
terminals in the connector of the main harness.
5. Start the engine. Run the engine at full throttle
and release the parking brake.
Note:
Ensure that the parking brake is engaged
and that the motion-control levers are out to start
the engine. You do not have to be in the seat.
6. Run the machine at least 5 minutes with the
drive levers in the full forward speed to bring
hydraulic fluid up to operating temperature.
Note:
The motion-control lever must be
in neutral while making any necessary
adjustments.
7. Bring the motion-control levers into the N
position.
8. Check and ensure that the control-plate tabs
touch the return-to-neutral plates on the
hydraulic units.
9. Adjust the pump-control-rod lengths by turning
the nut in the appropriate direction until the
wheels slightly creep in reverse (see
10. Move the motion-control levers to the R
position and while applying slight pressure to
the lever, allow the reverse indicator springs to
bring the levers back to neutral.
Note:
The wheels must stop turning or slightly
creep in reverse.
Note:
You may need to remove the
motion-control cover to gain access.
EUTRAL
1. Nut
2. Stationary plate
Figure 96).
3. Control plate
EVERSE
11. Shut off the machine.
12. Remove the jumper wire from the wire harness
and plug the connector into the seat switch.
13. Remove the jack stands.
14. Raise the mower deck and install the height of
cut pin.
15. Check and ensure that the machine does not
creep in neutral with the park brake disengaged.
68
Figure 96
4. Return-to-neutral plate
5. Tabs touching return to
neutral plate
g036753