Adjusting The Side Bumpers; Stopping The Machine - Toro TITAN HD 1500 Operator's Manual

2500 series mower deck shown
1. Anti-scalp roller
2. Spacer
3. Bushing
1500 and 2000 series mower deck shown
1. Flange nut
2. Bolt
3. Bushing

Adjusting the Side Bumpers

(Rear Discharge Machines Only)
Install the side bumpers in the top holes when
operating in a height of cut higher than 64 mm (2-1/2
inches) and in the center holes when operating in a
height of cut lower than 64 mm (2-1/2 inches).
Note:
When the bumpers become worn, switch the
bumpers to the opposite sides of the mower and flip
them over. This allows the bumpers to be used longer
before replacing them.
1. Disengage the blade-control switch (PTO), turn
the ignition key to off, move the levers to the
Figure 30
4. Flange nut
5. Bolt
Figure 31
4. Anti-scalp roller
5. Spacer
N
EUTRAL
and remove the key.
2. Shut off the engine, remove the key, and wait for
all moving parts to stop.
3. Raise the mower to the transport position.
4. Remove the bolts and nuts from each bumper
(Figure 32).
g038079
1. Bolt
2. Bumper
5. Move each bumper to the desired position and
secure them with the bolts and nuts.
Note:
Use only the top or center sets of holes to
adjust the bumpers. Use the bottom holes when
switching sides, at which time they become the
g036848
top holes on the other side of the mower.

Stopping the Machine

To stop the machine, move the motion-control levers
to neutral and then to the N
disengage the blade-control switch (PTO), and turn
the ignition key to the O
Set the parking brake when you leave the machine;
refer to Setting the Parking Brake (page
the key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
29
- position, apply the parking brake,
LOCK
Figure 32
3. Nut
-
EUTRAL LOCK
position.
FF
g037862
position,
23). Remove