Replacing The Hydraulic Pump-Drive Belt - Toro TITAN HD 1500 Operator's Manual

Replacing the Hydraulic
Pump-Drive Belt
1. Disengage the blade-control switch (PTO) and
set the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the mower belt; refer to
Mower Belt for Side Discharge Mower Decks
(page 63) or Replacing the Mower Belt for Rear
Discharge Mower Decks (page
4. Raise the machine and support it with jack
stands (Figure 93).
5. Remove the clutch stop
Figure 92
1. Clutch stop
6. Remove the idler spring from the post
93).
7. Remove the existing belt from the
hydraulic-unit-drive pulleys and the engine
pulley.
8. Install the new belt around the engine pulley and
the 2 hydraulic-pump pulleys
Replacing the
64).
(Figure 92).
g036860
(Figure
(Figure 93).
1. Idler pulley
2. Idler-spring post
3. Engine pulley
9. Install the clutch stop
10. Install the mower belt; refer to
(page 63).
66
Figure 93
4. Pump-drive belt
5. Right hydraulic-pump
pulley
6. Left hydraulic-pump pulley
(Figure 92).
Belt Maintenance
g036859