After Operation; After Operation Safety; Using The Fuel-Shutoff Valve; Using The Drive-Wheel-Release Valves - Toro TITAN HD 1500 Operator's Manual

After Operation

After Operation Safety

General Safety
•
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
•
Shut off the fuel before storing or transporting the
machine.
•
Disengage the drive to the attachment whenever
you are transporting or not using the machine.
•
Use full-width ramps for loading the machine into
a trailer or truck.
•
Tie the machine down securely using straps,
chains, cable, or ropes. Both front and rear straps
should be directed down and outward from the
machine.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Shut off the fuel before storing or transporting the
machine.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Using the Fuel-Shutoff
Valve
The fuel-shutoff valve is located behind the seat.
Close the fuel-shutoff valve for transport, maintenance,
and storage.
Ensure that the fuel-shutoff valve is open when
starting the engine.
1. O position
N
Using the
Drive-Wheel-Release
Valves
WARNING
Hands may become entangled in the rotating
drive components below the engine deck,
which could result in serious injury.
Shut off the engine, remove the key, and allow
all moving parts to stop before accessing the
drive-wheel-release valves.
WARNING
The engine and hydraulic-drive units can
become very hot. Touching a hot engine or
hydraulic-drive units can cause severe burns.
Allow the engine and hydraulic-drive units
to cool completely before accessing the
drive-wheel-release valves.
The drive-wheel-release valves are located on the left
and right sides underneath the engine deck.
1. Disengage the blade-control switch (PTO), turn
the ignition key to off, move the levers to the
31
Figure 33
2. O position
FF
g036849
g008948