Adjusting The Height-Of-Cut; Adjusting The Anti-Scalp Rollers - Toro TITAN HD 1500 Operator's Manual

Adjusting the Height-of-Cut

Using the Transport Lock
The transport lock has 2 positions, and is used with
the deck-lift pedal. There is a L
an U position for the transport position of the
NLOCK
mower deck (Figure 28).
Figure 28
Transport-Lock Positions
1. Transport lock knob
2. L position—The
OCK
mower deck locks into the
transport position.
position and
OCK
g037050
3. U position—The
NLOCK
mower deck does not lock
into the transport position.
Adjusting the Height-of-Cut Pin
Adjust the height-of-cut from 38 to 127 mm (1-1/2 to 5
inches) in 6 mm (1/4 inch) increments by moving the
height-of-cut pin into different hole locations.
1. Move the transport lock to the L
2. Push on the deck-lift pedal with your foot and
raise the mower deck to the T
(also the 127 mm or 5 inch cutting-height
position) as shown in
3. To adjust, remove the pin from the height-of-cut
bracket (Figure
4. Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin (Figure
5. Push on the deck lift, pull up on the transport
lock knob, and slowly lower the mower deck.
1. Deck-lift pedal
2. Height-of-cut holes
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut, adjust the
height of the anti-scalp rollers.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
28
position.
OCK
RANSPORT
Figure 29.
29).
29).
Figure 29
3. Height-of-cut pin
4. Transport lock knob
EUTRAL
position
g036745
-
LOCK