Breaking In A New Machine; Using Attachments And Accessories; During Operation; During Operation Safety - Toro TITAN HD 1500 Operator's Manual

Figure 12
1. Seat-suspension knob

Breaking in a New Machine

New engines take time to develop full power. Mower
decks and drive systems have higher friction when
new, placing additional load on the engine. Allow
40 to 50 hours of break-in time for new machines to
develop full power and best performance.
Using Attachments and
Accessories
Use only Toro approved attachments and accessories.
If more than one accessory-mount kit (i.e. bucket kit or
universal mount kit) is added to any of the 4 locations
shown in Figure 13, add a front-weight kit. Contact
your authorized service dealer for the front-weight kit.
Figure 13
1. Add a front-weight kit when 2 or more accessory-mount kits
are installed at these positions.

During Operation

During Operation Safety

General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
g024881 •
Wear appropriate clothing, including eye
protection; slip-resistant, substantial footwear; and
hearing protection. Tie back long hair and do not
wear jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Never carry passengers on the machine and keep
bystanders and pets away from the machine
during operation.
•
Operate the machine only in good visibility to avoid
holes or hidden hazards.
•
Avoid mowing on wet grass. Reduced traction
could cause the machine to slide.
•
Ensure that all drives are in neutral, the parking
brake is engaged, and you are in the operating
position before you start the engine.
•
Keep your hands and feet away from the cutting
units. Keep clear of the discharge opening at all
times.
•
Look behind and down before backing up to be
sure of a clear path.
•
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure your
vision.
•
Do not mow near drop-offs, ditches, or
embankments. The machine could suddenly roll
over if a wheel goes over the edge or if the edge
gives way.
•
Stop the blades whenever you are not mowing.
•
Stop the machine and inspect the blades after
striking an object or if there is an abnormal
vibration in the machine. Make all necessary
repairs before resuming operation.
•
Slow down and use caution when making turns
and crossing roads and sidewalks with the
g037417
machine. Always yield the right-of-way.
•
Disengage the drive to the cutting unit and shut
off the engine before adjusting the height of
cut (unless you can adjust it from the operating
position).
•
Never run an engine in an area where exhaust
gases are enclosed.
•
Never leave a running machine unattended.
21