Lubrication; Greasing The Machine - Toro TITAN HD 1500 Operator's Manual

Lubrication

Grease more frequently when operating conditions
are extremely dusty or sandy.
Grease Type: No. 2 lithium or molybdenum grease
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings with a rag.
Note:
Make sure to scrape any paint off the
front of the fitting(s).
4. Connect a grease gun to the fitting, and pump
grease into the fittings.
5. Wipe up any excess grease.

Greasing the Machine

Service Interval: Every 25 hours—For 1500 and
-
EUTRAL LOCK
1.
2.
3.
4.
1. Pump-idler pivot
2. Caster axle (1500 and
38
2000 Series machines—Grease the
front caster axles. (more often in
dirty or dusty conditions).
Every 50 hours—For 2500 Series
machines—Grease the mower deck-idler
pivot.
Every 50 hours—Grease the pump-idler pivot.
Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and set the parking brake.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
Grease the mower deck and pump idler-pulley
pivot with 1 or 2 pumps of grease
For 1500 and 2000 Series machines, grease the
front caster axles (Figure
Figure 38
2000 Series machines
only)
-
EUTRAL LOCK
(Figure 38).
38).
g037570
3. Mower deck idler-pulley
pivot (2500 Series
machines only)