Replacing The Mower Belt For Rear Discharge Mower Decks - Toro TITAN HD 1500 Operator's Manual

Figure 86
2500 Series Mower Decks
1. Clutch pulley
2. Mower belt
3. Spring-loaded idler pulley
8. Install the idler spring
Note:
Make sure to seat the spring ends in the
anchor grooves.
9. Install the belt covers
Figure 87
g036865
4. Ratchet
5. Square hole in the idler
arm for the ratchet
(Figure 84 or Figure 86).
(Figure 87).
g027730
Replacing the Mower Belt
for Rear Discharge Mower
Decks
Replacing the Counter-Rotating
Belt
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the mower to the 76 mm (3 inches) height
of cut.
4. Lift the floor pan up to gain access to the center
pulley.
5. Remove the plastic belt cover
6. Remove the 3 bolts holding the metal belt cover
in place and remove the metal belt cover.
1. Idler spring
2. Counter-rotating belt
3. Double pulley
7. Use a ratchet in the square hole in the idler arm
to remove tension on the idler spring
8. Remove the belt from the mower deck pulley
(Figure 88).
9. Remove the belt from the remaining pulleys
(Figure 88).
10. Route the new belt abound the mower pulleys.
64
EUTRAL
(Figure 89).
Figure 88
4. Idler pulley
5. Square hole in the idler
arm for the ratchet
(Figure
-
LOCK
g036862
88).