Drive System Maintenance; Checking The Tire Pressure; Releasing The Electric Brake - Toro 74760 Operator's Manual

Drive System
Maintenance

Checking the Tire Pressure

Service Interval: Every 25 hours—Check tire
pressure.
Maintain the air pressure in the front and rear tires as
specified. Uneven tire pressure can cause uneven
cut. Check the pressure at the valve stem
Check the tires when they are cold to get the most
accurate pressure reading.
Refer to the maximum pressure suggested by the tire
manufacturer on the sidewall of the caster wheel tires.
Inflate the rear drive wheel tires to 89.6 kPa (13 psi).
Figure 43
1. Valve stem
Releasing the Electric
Brake
The electric brake releases by manually rotating
the link arms forward. Once the electric brake is
energized the brake will reset.
To release the brake:
1. Turn the ignition key to the O
disconnect the battery.
2. Locate the shafts where the brake-link arms are
(Figure 43).
connected on both sides of the electric brake
(Figure
3. Rotate the shafts forward to release the brakes.
g000554
1. Rotate brake-link arm forward on the electric-brake-control
module
2. Left rear tire
41
FF
44).
Figure 44
position or
g027911