Toro TITAN HD 1500 Operator's Manual page 73

Figure 102
1. Blades front to rear
2. Blade tip
9. Set the anti-scalp rollers to top holes or remove
them completely for this adjustment.
10. For 60-inch mower decks only:
A. Raise the deck to the transport position
(12.7 cm or 5 inches).
B. Slowly loosen the adjusting screw on the
lift-assist spring until you can remove the
screw (see Figure
Note:
Save the screw for installation.
Figure 103
Rear discharge mower deck shown
1. Adjusting screw
2. Bracket
g037880
3. Measure from the tip of the
blade to the flat surface
here.
103).
g035850
3. Set the gap to 22 to 29
mm (7/8 to 1-1/8 inch).
11. Place 2 blocks (see Block Height and Rake
Table) under the rear edge of the cutting deck
skirt; 1 on each side of the cutting deck
104).
12. Set the height-of-cut lever to the 3 inch (76 mm)
position.
13. Place 2 blocks under each side of the front edge
of the deck, but not under the anti-scalp roller
brackets or welds.
1. Block—7.3 cm (2.87
inches)
Block Height and Rake Table
Deck Front Block Height
Size
All mower 7.3 cm (2.87 inches)
decks
14. Carefully rotate the blades side to side
101).
15. Loosen the locknuts
corners and ensure that the mower deck is
sitting securely on all 4 blocks.
16. Remove any slack from the deck hangers and
make sure the deck-lift foot lever is pushed back
against the stop.
17. Tighten the 4 locknuts.
73
Figure 104
Bottom view
2. Welds
Rake
4.8 to 6.4 mm (3/16 to 1/4
inch)
(Figure 105) on all 4
(Figure
g038090
(Figure