Toro TITAN HD 1500 Operator's Manual page 51

5. Remove the foam element from the paper
element (Figure
Servicing the Foam Element
Wash the foam element with water and replace it if
it is damaged.
Servicing the Paper Element
1. Lightly tap the element on a flat surface to
remove dust and dirt.
2. Inspect the element for tears, an oily film, and
damage to the seal.
Figure 63
64).
Figure 64
Important:
with pressurized air or liquids, such as
solvent, gas, or kerosene. Replace the paper
element if it is damaged or cannot be cleaned
thoroughly.
Servicing the Engine Oil
Oil Type: Detergent oil (API service SF, SG, SH, SJ,
or SL)
Crankcase Capacity: 2.4 L (80 oz) with oil filter
g027800
Viscosity: See the table below.
g027801
Checking the Engine-Oil Level
Service Interval: Before each use or daily—For Toro
Note:
Check the oil when the engine is cold.
WARNING
Contact with hot surfaces may cause personal
injury.
Keep hands, feet, face, clothing, and other
body parts away the muffler and other hot
surfaces.
g027802
Important:
Do not overfill the crankcase with oil,
because damage to the engine may result. Do not
run engine with oil below the Low mark, because
the engine may be damaged.
1. Park the machine on a level surface, disengage
the blade-control switch, shut off the engine,
engage the parking brake, and remove the key.
2. Make sure that the engine is shut off, level, and
is cool so that the oil has had time to drain into
the sump.
3. To keep dirt, grass clippings, etc., out of the
engine, clean the area around the oil-fill cap and
dipstick before removing it
51
Do not clean the paper element
Figure 65
engines—check the engine-oil level.
(Figure
g029683
66).