Servicing The Fuses - Toro TITAN HD 1500 Operator's Manual

Installing the Battery
1. Position the battery in the tray with the terminal
posts opposite from the hydraulic tank
74).
2. Install the positive (red) battery cable to the
positive (+) battery terminal.
3. Install the negative (black) battery cable and
ground wire to the negative (-) battery terminal.
4. Secure the cables with 2 bolts, 2 washers, and
2 locknuts (Figure
5. Slide the red terminal boot onto the positive (+)
battery terminal.
6. Secure the battery with the rubber strap
74).
Charging the Battery
WARNING
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep sparks
and flames away from the battery.
Important:
Always keep the battery fully charged
(1.265 specific gravity). This is especially
important to prevent battery damage when the
temperature is below 0°C (32°F).
1. Charge battery for 10 to 15 minutes at 25 to 30
A or for 30 minutes at 10 A.
2. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (Figure 75).
3. Install the battery in the machine and connect
the battery cables; refer to
(page 58).
Note:
Do not run the machine with the battery
disconnected; electrical damage may occur.
(Figure
74).
(Figure
Installing the Battery
1. Positive battery post
2. Negative battery post

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component and circuit for a malfunction or short.
The fuses are located on the right console next to the
seat (Figure 76).
1. To replace the fuses, pull out the fuse to remove
it.
2. Install a new fuse
1. Fuse cover
2. Fuse holder
58
Figure 75
3. Red (+) charger lead
4. Black (-) charger lead
(Figure 76).
Figure 76
3. Fuel-shutoff valve
g000960
g036858