Toro TITAN HD 1500 Operator's Manual page 65

11. Using the ratchet in the square hole, remove the
tension on the spring, and guide the new belt
around the idler pulley
Replacing the Mower Belt
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the mower to the 76 mm (3 inches) height
of cut.
4. Remove the belt covers
5. Remove the counter-rotating belt; refer to
Replacing the Counter-Rotating Belt (page
6. Use a ratchet in the square hole in the idler arm
to remove tension on the idler spring
7. Remove the belt from the mower-deck pulleys
and the clutch pulley.
8. Install the new belt around the mower pulleys
and the clutch pulley under the engine
90).
(Figure 88).
EUTRAL
(Figure 89).
Figure 89
(Figure
-
LOCK
1. Mower belt
2. Spring-loaded idler pulley
9. Using the ratchet in the square hole, install the
belt around the spring-loaded idler pulley
90).
Make sure that the spring ends are seated in
g009036
the anchor grooves.
10. Install the belt covers
64).
90).
(Figure
65
Figure 90
Rear discharge mower deck shown
3. Square hole in the idler
arm for the ratchet
4. Counter-rotating belt
(Figure
Figure 91
g036863
(Figure
91).
g009037