Toro TITAN HD 1500 Operator's Manual page 47

Note:
Replace a dirty, bent, or damaged
element. Handle the new element carefully;
do not use if the sealing surfaces are bent or
damaged.
2. Clean the air-cleaner base as required, and
check the condition.
Installing the Elements
1. Install the foam element onto the paper element.
2. Install the elements onto the air-cleaner base
(Figure 53).
3. Install the cover, and secure it with the latches
(Figure 52).
Servicing the Engine Oil
Oil Type: Detergent oil (API service SJ or higher)
Crankcase Capacity: 1.9 L (64 oz) when the filter
is changed
Viscosity: See the table below.
Checking the Engine-Oil Level
Service Interval: Before each use or daily
1. Park the machine on a level surface, disengage
the blade-control switch, shut off the engine,
and remove the key.
2. Make sure that the engine is shut off, level, and
is cool, so the oil has time to drain into the sump.
3. Check the engine-oil level
Figure 54
(Figure 55).
Changing the Engine Oil and the Engine-Oil
Filter
Service Interval: Every 100 hours—For Kohler
Note:
The drain plug is attached to the drain hose.
g017552
Note:
Dispose of the used oil at a recycling center.
Fill with oil as specified in the "Viscosity Grades" table
(Figure 54).
1. Park the machine, so that the drain side is
slightly lower than the opposite side, to ensure
that the oil drains completely.
2. Disengage the blade-control switch and move
the motion controls outward to the P
3. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
47
Figure 55
engines—change the engine oil and
the engine-oil filter.
g027515
position.
ARK