Lubrication; Greasing The Bearings And Bushings - Toro Groundsmaster 5910 Operator's Manual

Figure 46
1. Slide the cover inward
approximately 2.5 cm (1
inch).
6. Lift the front edge and guide it between the lift arm
and the roller to remove it
Figure 47
1. Slide the cover out between the lift arm and roller.
Installing the Inner-Wing-Deck Covers
1. Lower the wing deck onto a level surface.
2. Slide the cover into position by guiding the rear edge
between the lift arm and the roller.
3. While sliding the cover away from the traction unit,
guide the outside edge under the front and rear brackets
on the deck.
4. Align the deck mounting posts with the holes in the
cover and lower the cover into position.
5. Install the bolt securing the belt cover, if so equipped.
6. Engage the deck-cover latch.
2. Disengage these cover
edges.
(Figure 47).

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Before each use or daily—Lubricate the
caster-arm bushings.
Every 50 hours—Lubricate all grease fittings.
The machine has grease fittings that you must lubricate
regularly with No. 2 lithium grease. Also, lubricate the
machine immediately after every washing.
Note: Lubricate the caster-fork-shaft bushings before
each use or daily.
Traction Unit
•
2 impact arms (Figure
•
2 front deck-lift-cylinder pivots
•
2 side deck-lift-cylinder pivots
•
4 steering-cylinder-ball joints
•
2 tie-rod-ball joints
•
2 king-pin bushings
•
1 rear axle-pivot bushing
•
1 brake-shaft-pivot bearing
40
48)
(Figure 48)
(Figure 48)
(Figure 49)
(Figure 49)
(Figure 49)
(Figure 50)
(Figure 51)