Installing The Control Valve Into The Pipeline - Samson 5824 Mounting And Operating Instructions

5.2 Installing the control valve
into the pipeline
Î Install the valve into the pipeline accord-
ing the specifications in the mounting
and operating instructions of the valve.
Î The control valve can be installed in the
pipeline in any desired position. Howev-
er, a suspended mounting position of the
actuator is not permissible (see Fig. 8).
EB 5824-2 EN
Note
The degree of protection IP 54 can only
be achieved up to device index .03 when
the actuator is installed in the upright
position. See the last two figures of the
configuration ID written on the nameplate
(see page 11) for the device index.
Fig. 8: Mounting position
Mounting and start-up
!
27