Configuring An Ospfv3 Sham Link - HPE FlexFabric 5950 Series Configuration Manual

224.0.0.0/4
224.0.0.0/24
255.255.255.255/32 Direct
# Verify that the VPN routing table contains the remote VPN route.
[PE3] display ipv6 routing-table vpn-instance vpn1
Destinations : 6 Routes : 6
Destination: ::1/128
NextHop
Interface
Destination: 2001:1::/96
NextHop
Interface
Destination: 2001:1::2/128
NextHop
Interface
Destination: 2001:2::/96
NextHop
Interface
Destination: FE80::/10
NextHop
Interface
Destination: FF00::/8
NextHop
Interface
4. Verify that PE 3 and PE 4 can ping each other. (Details not shown.)
5. Verify that CE 3 and CE 4 can ping each other. (Details not shown.)
C onfiguring an OSPFv3 sham link
2 7 9 B
N etwork requirements
5 4 6 B
As shown in
PE 1 and PE 2 so traffic between the CEs is forwarded through the MPLS backbone instead of the
backdoor link.
Direct
Direct
: ::1
: InLoop0
: ::
: Vlan11
: ::1
: InLoop0
: ::FFFF:6.6.6.9
: Vlan12
: ::
: InLoop0
: ::
: NULL0
F igure 88, CE 1 and CE 2 belong to VPN 1. Configure an OSPFv3 sham link between
8 4 8 H
0 0 0.0.0.0
0 0 0.0.0.0
0 0 127.0.0.1
347
NULL0
NULL0
InLoop0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : BGP4+
Preference: 255
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0