HPE FlexFabric 5950 Series Configuration Manual page 394

Figure 96 Network diagram
C onfiguration procedure
5 7 5 B
1. Create VPN instances on the MCE and PE 1, and bind the VPN instances to VLAN interfaces.
For the configuration procedure, see "
routes to the
2. Configure routing between the MCE and VPN sites:
# Enable an OSPF process on the devices in the two VPNs, and advertise the subnets. (Details
not shown.)
# Configure OSPF on the MCE, and bind OSPF process 10 to VPN instance vpn1 to learn the
routes of VPN 1.
<MCE> system-view
[MCE] ospf 10 router-id 10.10.10.1 vpn-instance vpn1
[MCE-ospf-10] area 0
[MCE-ospf-10-area-0.0.0.0] network 10.214.10.0 0.0.0.255
[MCE-ospf-10-area-0.0.0.0] quit
[MCE-ospf-10] quit
# Display the routing table of VPN 1 on the MCE.
[MCE] display ip routing-table vpn-instance vpn1
Destinations : 13
Destination/Mask
0.0.0.0/32
10.214.10.0/24
10.214.10.0/32
PE."
Routes : 13
Proto Pre Cost
Direct 0
Direct 0
Direct 0
C onfiguring the MCE that uses OSPF to advertise VPN
8 6 9 H
NextHop
0 127.0.0.1
0 10.214.10.3
0 10.214.10.3
386
Interface
InLoop0
Vlan10
Vlan10