Configuring Routing On An Mce - HPE FlexFabric 5950 Series Configuration Manual

Step
3. Configure route targets.
4. Set the maximum
number of active routes.
5. Apply an import routing
policy.
6. Apply an export routing
policy.
7. Apply a tunnel policy to
the VPN instance.

Configuring routing on an MCE

1 2 2 B
MCE implements service isolation through route isolation. MCE routing configuration includes the
following:
•
MCE-VPN site routing configuration.
•
MCE-PE routing configuration.
On the PE, perform the following tasks:
•
Disable routing loop detection to avoid route loss during route calculation.
•
Disable route redistribution between routing protocols to save system resources.
Before you configure routing on an MCE, configure VPN instances, and bind the VPN instances to
the interfaces connected to the VPN sites and the PE.
Command
b. address-family ipv4
vpn-target vpn-target&<1-8> [ both |
export-extcommunity |
import-extcommunity ]
routing-table limit number
{ warn-threshold | simply-alert }
import route-policy route-policy
export route-policy route-policy
tnl-policy tunnel-policy-name
372
Remarks
instance view.
By default, no route targets are
configured.
By default, the number of active
routes ain a VPN instance is not
limited.
Setting the maximum number of
active routes for a VPN instance
can prevent the PE from learning
too many routes.
By default, all routes matching the
import target attribute are
accepted.
The specified routing policy must
have been created.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, routes to be advertised
are not filtered.
The specified routing policy must
have been created.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, only one tunnel is
selected (no load balancing). The
LSP tunnel takes precedence
over the CR-LSP tunnel.
The specified tunnel policy must
have been created.
For information about tunnel
policies, see " Configuring tunnel
8 6 5 H
policies."