HPE FlexFabric 5950 Series Configuration Manual page 178

[SwitchA-Tunnel1] mpls te bandwidth 2000
[SwitchA-Tunnel1] quit
7. Configure a static route on Switch A to direct the traffic destined for subnet 100.1.2.0/24 to the
MPLS TE tunnel 1 for forwarding.
[SwitchA] ip route-static 100.1.2.0 24 tunnel 1 preference 1
V erifying the configuration
4 3 5 B
# Verify that the tunnel interface is up on Switch A.
[SwitchA] display interface tunnel
Tunnel1
Current state: UP
Line protocol state: UP
Description: Tunnel1 Interface
Bandwidth: 64kbps
Maximum transmission unit: 64000
Internet address: 7.1.1.1/24 (primary)
Tunnel source unknown, destination 4.4.4.9
Tunnel TTL 255
Tunnel protocol/transport CR_LSP
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 6 bytes/sec, 48 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 177 packets, 11428 bytes, 0 drops
# Display detailed information about the MPLS TE tunnel on Switch A.
[SwitchA] display mpls te tunnel-interface
Tunnel Name
Tunnel State
Tunnel Attributes
LSP ID
Admin State
Ingress LSR ID
Signaling
Resv Style
Tunnel mode
Reverse-LSP name
Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
Backup Explicit Path : -
Metric Type
Record Route
FRR Flag
Backup Bandwidth Type: -
Route Pinning
Retry Limit
: Tunnel 1
: Up (Main CRLSP up, Shared-resource CRLSP down)
:
: 23331 Tunnel ID
: Normal
: 1.1.1.9 Egress LSR ID
: RSVP-TE Static CRLSP Name
: SE
: -
: -
: - Reverse-LSP Tunnel ID: -
: CT0 Tunnel Bandwidth
: 2000 kbps
: 7 Holding Priority
: 0/0
: -
: TE
: Disabled Record Label
: Disabled Backup Bandwidth Flag: Disabled
Backup Bandwidth
: Disabled
: 10 Retry Interval
170
: 1
: 4.4.4.9
: -
: 2000 kbps
: 7
: Disabled
: -
: 2 sec