Configuring A Preemption Mode For A Smart Link Group; Enabling The Sending Of Flush Messages; Configuring Collaboration Between Smart Link And Track - HPE FlexNetwork 5510 HI Series Configuration Manual

Step
Enter system view.
1.
Enter Layer 2 Ethernet
2.
interface view or Layer 2
aggregate interface view.
Configure member ports for a
3.
smart link group.

Configuring a preemption mode for a smart link group

Step
Enter system view.
1.
Enter smart link group view.
2.
Configure a preemption
3.
mode for the smart link
group.
Configure the preemption
4.
delay.

Enabling the sending of flush messages

Follow these guidelines when you enable the sending of flush messages:
• The control VLAN configured for a smart link group must be different from the control VLAN
configured for any other smart link group.
• Make sure the configured control VLAN already exists, and assign the smart link group member
ports to the control VLAN.
• The control VLAN of a smart link group must also be one of its protected VLANs. Do not remove
the control VLAN. Otherwise, flush messages cannot be sent correctly.
To enable the sending of flush messages:
Step
Enter system view.
1.
Enter smart link group
2.
view.
Enable flush update.
3.

Configuring collaboration between Smart Link and Track

Smart Link collaborates with the CC function of CFD through track entries to implement link
detection. Before configuring the collaboration between Smart Link and Track on a port, make sure
the port has been added to the specified smart link group.
Command
system-view
interface interface-type
interface-number
port smart-link group group-id
{ primary | secondary }
Command
system-view
smart-link group group-id
preemption mode { role | speed
[ threshold threshold-value ] }
preemption delay delay
Command
system-view
smart-link group group-id
flush enable [ control-vlan
vlan-id ]
146
Remarks
N/A
N/A
By default, an interface is not
a smart link group member.
Remarks
N/A
N/A
By default, preemption is
disabled.
By default, the preemption delay
is 1 second.
The preemption delay
configuration takes effect only
after a preemption mode is
configured.
Remarks
N/A
N/A
By default, flush update is enabled, and
VLAN 1 is the control VLAN.