HPE FlexFabric 5950 Series Configuration Manual page 144

Figure 37 Network diagram
Table 8 Interface and IP address assignment
Device
Switch A
Switch B
Switch D
C onfiguration procedure
4 2 2 B
Before configuration, disable the spanning tree feature globally or map each VLAN to an MSTI. For
more information, see Layer 2—LAN Switching Configuration Guide.
1. Configure IP addresses and masks for interfaces. (Details not shown.)
2. Configure IS-IS to advertise interface addresses, including the loopback interface address.
(Details not shown.)
3. Configure an LSR ID, and enable MPLS, MPLS TE, and RSVP-TE on each switch. Enable BFD
for RSVP-TE on Switch B and Switch C:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] mpls lsr-id 1.1.1.1
Interface IP address
Loop0 1.1.1.1/32
Vlan-int1 2.1.1.1/24
Loop0 2.2.2.2/32
Vlan-int1 2.1.1.2/24
Vlan-int2 3.1.1.1/24
Vlan-int4 3.2.1.1/24
Vlan-int6 3.3.1.1/24
Loop0 4.4.4.4/32
Vlan-int3 4.1.1.2/24
Vlan-int7 4.2.1.2/24
Device Interface
Switch E Loop0
Vlan-int4
Vlan-int5
Switch C Loop0
Vlan-int3
Vlan-int2
Vlan-int5
Switch F Loop0
Vlan-int6
Vlan-int7
136
IP address
5.5.5.5/32
3.2.1.2/24
3.4.1.1/24
3.3.3.3/32
4.1.1.1/24
3.1.1.2/24
3.4.1.2/24
6.6.6.6/32
3.3.1.2/24
4.2.1.1/24