HPE FlexFabric 5950 Series Configuration Manual page 386

Step
2. Create a RIP process for
a VPN instance and enter
RIP view.
3. Enable RIP on the
interface attached to the
specified network.
4. Redistribute the VPN
routes.
C onfiguring OSPF between an MCE and a PE
5 6 7 B
Step
1. Enter system view.
2. Create an OSPF process for
a VPN instance and enter
OSPF view.
3. Disable routing loop
detection.
4. Redistribute the VPN routes.
5. Create an OSPF area and
enter OSPF area view.
6. Enable OSPF on the
interface attached to the
specified network in the area.
C onfiguring IS-IS between an MCE and a PE
5 6 8 B
Step
1. Enter system view.
2. Create an IS-IS
process for a VPN
instance and enter
IS-IS view.
3. Configure a network
entity title.
4. Create the IS-IS IPv4
unicast address family
and enter its view.
5. Redistribute VPN
routes.
Command
rip [ process-id ] vpn-instance
vpn-instance-name
network network-address
import-route protocol [ process-id |
all-processes | allow-ibgp ]
[ allow-direct | cost cost-value |
route-policy route-policy-name | tag tag ]
*
Command
system-view
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
vpn-instance-capability simple
import-route protocol
[ process-id | all-processes |
allow-ibgp ] [ allow-direct | cost
cost-value | nssa-only |
route-policy route-policy-name |
tag tag | type type ] *
area area-id
network ip-address
wildcard-mask
Command
system-view
isis [ process-id ] vpn-instance
vpn-instance-name
network-entity net
address-family ipv4 [ unicast ]
import-route protocol [ process-id |
all-processes | allow-ibgp ]
378
Remarks
N/A
By default, RIP is disabled on
an interface.
By default, no routes are
redistributed into RIP.
Remarks
N/A
N/A
By default, routing loop detection
is enabled.
You must disable routing loop
detection for a VPN OSPF
process on the MCE. Otherwise,
the MCE does not receive OSPF
routes from the PE.
By default, no routes are
redistributed into OSPF.
By default, no OSPF areas exist.
By default, an interface neither
belongs to any area nor runs
OSPF.
Remarks
N/A
N/A
By default, no NET is configured.
By default, the IS-IS IPv4 unicast
address family is not created.
By default, IS-IS does not
redistribute routes from any other