C Onfiguring Routing Between An Mce And A Pe - HPE FlexFabric 5950 Series Configuration Manual

2. Configure a VPN site:
Step
1. Enter system view.
2. Enter BGP instance view.
3. Configure the MCE as an
IBGP peer.
4. Enter BGP-VPN IPv4
unicast address family
view.
5. Enable BGP to exchange
IPv4 unicast routes with the
peer.
6. Redistribute the IGP routes
of the VPN into BGP.

C onfiguring routing between an MCE and a PE

3 0 2 B
MCE-PE routing configuration includes these tasks:
•
Binding the MCE-PE interfaces to VPN instances.
•
Performing route configurations.
•
Redistributing VPN routes into the routing protocol running between the MCE and the PE.
Perform the following configurations on the MCE. Configure the PE in the same way that you
configure a PE in a basic MPLS L3VPN. For more information about configuring the PE, see
" C onfiguring MPLS
8 6 6 H
C onfiguring static routing between an MCE and a PE
5 6 5 B
Step
1. Enter system view.
2. Configure a static route
for a VPN instance.
3. (Optional.) Set the
default preference for
static routes.
C onfiguring RIP between an MCE and a PE
5 6 6 B
Step
1. Enter system view.
Command
system-view
bgp as-number [ instance
instance-name ]
[ multi-session-thread ]
peer { group-name |
ipv4-address [ mask-length ] }
as-number as-number
address-family ipv4 [ unicast ]
peer { group-name |
ipv4-address [ mask-length ] }
enable
import-route protocol
[ { process-id | all-processes }
[ allow-direct | med med-value
| route-policy
route-policy-name ] * ]
L3VPN."
Command
system-view
ip route-static vpn-instance s-vpn-instance-name
dest-address { mask-length | mask } { interface-type
interface-number [ next-hop-address ] |
next-hop-address [ public ] [ track
track-entry-number ] | vpn-instance
d-vpn-instance-name next-hop-address [ track
track-entry-number ] } [ permanent ] [ preference
preference ] [ tag tag-value ] [ description text ]
ip route-static default-preference
default-preference
Command
system-view
377
Remarks
N/A
By default, BGP is not enabled.
By default, no BGP peers or
peer groups exist.
N/A
By default, BGP does not
exchange IPv4 unicast routes
with any peer.
By default, no routes are
redistributed into BGP.
A VPN site must advertise VPN
network addresses to the
connected MCE.
Remarks
N/A
By default, no
static routes are
configured.
The default
preference is 60.
Remarks
N/A