HPE FlexFabric 5950 Series Configuration Manual page 117

Figure 32 Network diagram
Table 4 Interface and IP address assignment
Device
Switch A
Switch B
C onfiguration procedure
4 0 7 B
1. Configure IP addresses and masks for interfaces. (Details not shown.)
2. Configure OSPF to advertise routes within the ASs, and redistribute the direct and BGP routes
into OSPF on Switch B and Switch C:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] ospf
[SwitchA-ospf-1] area 0
[SwitchA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[SwitchA-ospf-1-area-0.0.0.0] network 1.1.1.9 0.0.0.0
[SwitchA-ospf-1-area-0.0.0.0] quit
[SwitchA-ospf-1] quit
# Configure Switch B.
<SwitchB> system-view
[SwitchB] ospf
[SwitchB-ospf-1] import-route direct
[SwitchB-ospf-1] import-route bgp
[SwitchB-ospf-1] area 0
[SwitchB-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[SwitchB-ospf-1-area-0.0.0.0] network 2.2.2.9 0.0.0.0
Interface IP address
Loop0 1.1.1.9/32
Vlan-int1 10.1.1.1/24
Vlan-int10 100.1.1.1/24
Loop0 2.2.2.9/32
Vlan-int1 10.1.1.2/24
Vlan-int2 20.1.1.1/24
Device Interface
Switch D Loop0
Vlan-int3
Vlan-int10
Switch C Loop0
Vlan-int3
Vlan-int2
109
IP address
4.4.4.9/32
30.1.1.2/24
100.1.2.1/24
3.3.3.9/32
30.1.1.1/24
20.1.1.2/24