Protocols And Standards; Rsvp Configuration Task List; Enabling Rsvp; Configuring Rsvp Refresh - HPE FlexFabric 5950 Series Configuration Manual

P rotocols and standards
2 1 4 B
•
RFC 2205, Resource ReSerVation Protocol
•
RFC 3209, RSVP-TE: Extensions to RSVP for LSP Tunnels
•
RFC 2961, RSVP Refresh Overhead Reduction Extensions

RSVP configuration task list

7 4 B
Tasks at a glance
(Required.)
(Optional.) Perform the following tasks on each node of an MPLS TE tunnel according to your network
requirements:
•
C onfiguring RSVP refresh
7 4 8 H
•
C onfiguring RSVP Srefresh and reliable RSVP message delivery
7 4 9 H
•
C onfiguring RSVP hello extension
7 5 0 H
•
C onfiguring RSVP authentication
7 5 1 H
•
S etting a DSCP value for outgoing RSVP packets
7 5 2 H
•
C onfiguring RSVP GR
7 5 3 H
•
E nabling BFD for RSVP
7 5 4 H

Enabling RSVP

7 5 B
Step
1. Enter system view.
2. Enable global RSVP and enter
RSVP view.
3. Return to system view.
4. Enter interface view.
5. Enable RSVP on the interface.

Configuring RSVP refresh

7 6 B
Step
1. Enter system view.
2. Enter RSVP view.
3. Set the refresh interval for
Path and Resv messages.
4. Set the PSB and RSB
timeout multiplier.
Enabling RSVP
7 4 7 H
Command
system-view
rsvp
quit
interface interface-type
interface-number
rsvp enable
Command
system-view
rsvp
refresh interval interval
keep-multiplier number
160
Remarks
N/A
By default, global RSVP is
disabled.
N/A
N/A
By default, RSVP is disabled
on the interface.
Remarks
N/A
N/A
By default, the refresh interval is
30 seconds for both path and
Resv messages.
By default, the PSB and RSB
timeout multiplier is 3.