HPE FlexFabric 5950 Series Configuration Manual page 142

[SwitchB] display mpls lsp
FEC
1.1.1.1/4/614000
Backup
2.2.2.2/5/30914
3.2.1.2
3.1.1.2
[SwitchE] display mpls lsp
FEC
2.2.2.2/5/30914
3.3.1.2
# Shut down the protected interface VLAN-interface 2 on the PLR (Switch B).
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] shutdown
[SwitchB-Vlan-interface2] quit
# Execute the display interface tunnel 4 command on Switch A to display information about the
primary CRLSP. The output shows that the tunnel interface is still up. (Details not shown.)
# Display detailed information about the tunnel interface on Switch A.
[SwitchA] display mpls te tunnel-interface
Tunnel Name
Tunnel State
Tunnel Attributes
LSP ID
Admin State
Ingress LSR ID
Signaling
Resv Style
Tunnel mode
Reverse-LSP name
Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
Backup Explicit Path : -
Metric Type
Record Route
FRR Flag
Backup Bandwidth Flag: Disabled
Backup Bandwidth
Bypass Tunnel
Route Pinning
Retry Limit
Reoptimization
Backup Type
Auto Bandwidth
Min Bandwidth
Proto In/Out Label
RSVP 1245/3
1245/3
RSVP -/1150
Local -/-
Local -/-
Proto In/Out Label
RSVP 1150/3
Local -/-
: Tunnel 4
: Up (Main CRLSP up, Shared-resource CRLSP being set up)
:
: 18753 Tunnel ID
: Normal
: 1.1.1.1 Egress LSR ID
: RSVP-TE Static CRLSP Name
: SE
: -
: -
: - Reverse-LSP Tunnel ID: -
: CT0 Tunnel Bandwidth
: 0 kbps
: 7 Holding Priority
: 0/0
: pri-path
: TE
: Enabled Record Label
: Enabled Bandwidth Protection : Disabled
Backup Bandwidth Type: -
: -
: No Auto Created
: Disabled
: 10 Retry Interval
: Disabled Reoptimization Freq
: None Backup LSP ID
: Disabled Auto Bandwidth Freq
: - Max Bandwidth
134
Interface/Out NHLFE
Vlan2
Tun5
Vlan2
Vlan4
Vlan2
Interface/Out NHLFE
Vlan5
Vlan5
: 4
: 3.3.3.3
: -
: 0 kbps
: 7
: Enabled
: No
: 2 sec
: -
: -
: -
: -