HPE FlexFabric 5950 Series Configuration Manual page 406

C onfiguring IPv6 static routing between an MCE and a PE
5 8 3 B
Step
1. Enter system view.
2. Configure an IPv6
static route for an IPv6
VPN instance.
3. (Optional.) Set the
default preference for
IPv6 static routes.
C onfiguring RIPng between an MCE and a PE
5 8 4 B
Step
1. Enter system view.
2. Create a RIPng process for
an IPv6 VPN instance and
enter RIPng view.
3. Redistribute VPN routes.
4. Return to system view.
5. Enter interface view.
6. Enable the RIPng process on
the interface.
C onfiguring OSPFv3 between an MCE and a PE
5 8 5 B
Step
1. Enter system view.
2. Create an OSPFv3 process
for an IPv6 VPN instance
and enter OSPFv3 view.
3. Set the router ID.
4. Disable routing loop
detection.
5. Redistribute VPN routes.
Command
system-view
ipv6 route-static vpn-instance
s-vpn-instance-name ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | nexthop-address [ public ]
| vpn-instance d-vpn-instance-name
nexthop-address } [ permanent ] [ preference
preference ] [ tag tag-value ] [ description text ]
ipv6 route-static default-preference
default-preference
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol [ process-id ]
[ allow-ibgp ] [ allow-direct | cost
cost-value | route-policy
route-policy-name ] *
quit
interface interface-type
interface-number
ripng process-id enable
Command
system-view
ospfv3 [ process-id |
vpn-instance
vpn-instance-name ] *
router-id router-id
vpn-instance-capability simple
import-route protocol
[ process-id | all-processes |
allow-ibgp ] [ allow-direct | cost
cost-value | nssa-only |
route-policy route-policy-name |
398
Remarks
N/A
By default, no IPv6 static
routes are configured.
The default value is 60.
Remarks
N/A
N/A
By default, no routes are
redistributed into RIPng.
N/A
N/A
By default, RIPng is disabled
on an interface.
Remarks
N/A
N/A
N/A
By default, routing loop detection
is enabled.
On an MCE network, you must
disable routing loop detection for
a VPN OSPFv3 process.
Otherwise, the MCE does not
receive OSPFv3 routes from the
PE.
By default, no routes are
redistributed into OSPFv3.