HPE FlexFabric 5950 Series Configuration Manual page 109

7. Configure a static route on Switch A to direct traffic destined for subnet 100.1.2.0/24 to MPLS
TE tunnel 0.
[SwitchA] ip route-static 100.1.2.0 24 tunnel 0 preference 1
V erifying the configuration
4 0 2 B
# Verify that the tunnel interface is up on Switch A.
[SwitchA] display interface tunnel
Tunnel0
Current state: UP
Line protocol state: UP
Description: Tunnel0 Interface
Bandwidth: 64kbps
Maximum transmission unit: 1496
Internet address: 6.1.1.1/24 (primary)
Tunnel source unknown, destination 3.3.3.3
Tunnel TTL 255
Tunnel protocol/transport CR_LSP
Output queue - Urgent queuing: Size/Length/Discards 0/100/0
Output queue - Protocol queuing: Size/Length/Discards 0/500/0
Output queue - FIFO queuing: Size/Length/Discards 0/75/0
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
# Display detailed information about the MPLS TE tunnel on Switch A.
[SwitchA] display mpls te tunnel-interface
Tunnel Name
Tunnel State
Tunnel Attributes
LSP ID
Admin State
Ingress LSR ID
Signaling
Resv Style
Tunnel mode
Reverse-LSP name
Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
Backup Explicit Path : -
Metric Type
Record Route
FRR Flag
Backup Bandwidth Flag: -
Backup Bandwidth
: Tunnel 0
: Up (Main CRLSP up)
:
: 1 Tunnel ID
: Normal
: 1.1.1.1 Egress LSR ID
: Static Static CRLSP Name
: -
: -
: -
: - Reverse-LSP Tunnel ID: -
: - Tunnel Bandwidth
: -
: 0 Holding Priority
: -/-
: -
: TE
: - Record Label
: - Bandwidth Protection : -
Backup Bandwidth Type: -
: -
101
: 0
: 3.3.3.3
: static-cr-lsp-1
: -
: 0
: -