Configuring Routing Between A Pe And A Ce - HPE FlexFabric 5950 Series Configuration Manual

Step
3. Configure route targets.
4. Set the maximum number of
active routes.
5. Apply an import routing
policy.
6. Apply an export routing
policy.
7. Apply a tunnel policy to the
VPN instance.
C onfiguring routing between a PE and a CE
2 6 6 B
You can configure IPv6 static routing, RIPng, OSPFv3, IPv6 IS-IS, EBGP, or IBGP between a PE and
a CE.
C onfiguring IPv6 static routing between a PE and a CE
5 2 2 B
Step
1. Enter system view.
2. Configure an IPv6 static
route for a VPN
instance.
Command
vpn-instance-name
b. address-family ipv6
vpn-target vpn-target&<1-8>
[ both | export-extcommunity |
import-extcommunity ]
routing-table limit number
{ warn-threshold | simply-alert }
import route-policy route-policy
export route-policy route-policy
tnl-policy tunnel-policy-name
Command
system-view
ipv6 route-static vpn-instance
s-vpn-instance-name ipv6-address
prefix-length { interface-type interface-number
303
Remarks
over the configurations in VPN
instance view.
By default, no route targets are
configured.
By default, the number of active
routes in a VPN instance is not
limited.
Setting the maximum number of
active routes for a VPN instance
can prevent the PE from storing
too many routes.
By default, all routes matching the
import target attribute are
accepted.
Make sure the routing policy
already exists. Otherwise, the
device does not filter received
routes.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, routes to be advertised
are not filtered.
Make sure the routing policy
already exists. Otherwise, the
device does not filter routes to be
advertised.
For information about routing
policies, see Layer 3—IP Routing
Configuration Guide.
By default, only one tunnel is
selected (no load balancing). The
LSP tunnel takes precedence
over the CR-LSP tunnel.
The specified tunnel policy must
have been created.
For information about tunnel
policies, see " Configuring tunnel
8 3 9 H
policies."
Remarks
N/A
By default, no IPv6 static
route is configured for a
VPN instance.