Configuring Bgp As Number Substitution And Soo Attribute - HPE FlexFabric 5950 Series Configuration Manual

NextHop
Interface
Destination: 100::/96
NextHop
Interface
Destination: 200::/96
NextHop
Interface
Destination: FE80::/10
NextHop
Interface
Destination: FF00::/8
NextHop
Interface
# Verify that VLAN-interface 12 of CE 1 and VLAN-interface 13 of CE 2 can ping each other. (Details
not shown.)
C onfiguring BGP AS number substitution and SoO attribute
2 8 1 B
N etwork requirements
5 5 2 B
CE 1, CE 2, and CE 3 belong to VPN 1, and are connected to PE1, PE 2, and PE 3. CE 1 and CE 2
reside in the same site. CE1, CE2, and CE 3 all use AS number 600.
To avoid route loss, configure BGP AS number substitution on PEs.
To avoid routing loops, configure the same SoO attribute on PE 1 and PE 2 for CE 1 and CE 2.
Figure 90 Network diagram
Loop0
VPN 1
AS 600
: ::1
: InLoop0
: 10:2::1
: Vlan-int12
: ::
: NULL0
: ::
: NULL0
: ::
: NULL0
CE 1
Vlan-int2
Vlan-int2
Loop0 Vlan-int3
Vlan-int4
PE 1
PE 2
Vlan-int4
Loop0 Vlan-int5
Vlan-int2
CE 2
Vlan-int2
MPLS backbone
AS 100
Loop0
Vlan-int3
Vlan-int6
Vlan-int6
Vlan-int5
P
356
Preference: 0
Cost : 0
Protocol : BGP4+
Preference: 255
Cost : 0
Protocol : Static
Preference: 60
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Protocol : Direct
Preference: 0
Cost : 0
Loop0
Vlan-int7
PE 3
CE 3
Vlan-int7
VPN 1
AS 600
Loop0