HPE FlexFabric 5950 Series Configuration Manual page 387

Step
6. Return to system view.
7. Enter interface view.
8. Enable the IS-IS
process on the
interface.
C onfiguring EBGP between an MCE and a PE
5 6 9 B
Step
1. Enter system view.
2. Enter BGP instance
view.
3. Enter BGP-VPN
instance view.
4. Configure the PE as an
EBGP peer.
5. Enter BGP-VPN IPv4
unicast address family
view.
6. Enable BGP to
exchange IPv4 unicast
routes with the peer.
7. Redistribute the VPN
routes of the VPN site.
C onfiguring IBGP between an MCE and a PE
5 7 0 B
Step
1. Enter system view.
2. Enter BGP instance view.
3. Enter BGP-VPN instance
view.
4. Configure the PE as an IBGP
peer.
5. Enter BGP-VPN IPv4 unicast
address family view.
6. Enable BGP to exchange
IPv4 unicast routes with the
peer.
Command
[ allow-direct | cost cost-value |
cost-type { external | internal } |
[ level-1 | level-1-2 | level-2 ] |
route-policy route-policy-name | tag
tag ] *
quit
interface interface-type
interface-number
isis enable [ process-id ]
Command
system-view
bgp as-number [ instance instance-name ]
[ multi-session-thread ]
ip vpn-instance vpn-instance-name
peer { group-name | ipv4-address
[ mask-length ] } as-number as-number
address-family ipv4 [ unicast ]
peer { group-name | ipv4-address
[ mask-length ] } enable
import-route protocol [ process-id |
all-processes ] [ allow-direct | med
med-value | route-policy
route-policy-name ] *
Command
system-view
bgp as-number [ instance
instance-name ]
[ multi-session-thread ]
ip vpn-instance vpn-instance-name
peer { group-name | ipv4-address
[ mask-length ] } as-number
as-number
address-family ipv4 [ unicast ]
peer { group-name | ipv4-address
[ mask-length ] } enable
379
Remarks
routing protocol.
If you do not specify the route level
in the command, the command
redistributes routes to the level-2
routing table by default.
N/A
N/A
By default, no IS-IS process is
enabled on the interface.
Remarks
N/A
By default, BGP is not
enabled.
N/A
By default, no BGP peers or
peer groups exist.
N/A
By default, BGP does not
exchange IPv4 unicast routes
with any peer.
By default, no routes are
redistributed into BGP.
Remarks
N/A
By default, BGP is not
enabled.
N/A
By default, no BGP peers or
peer groups exist.
N/A
By default, BGP does not
exchange IPv4 unicast routes
with any peer.