HPE FlexFabric 5950 Series Configuration Manual page 349

Figure 87 Network diagram
Loop0
Customer carrier
Vlan-int12
Vlan-int11
PE 3
Vlan-int11
AS 65410
C onfiguration procedure
5 4 4 B
1. Configure MPLS L3VPN on the provider carrier backbone. Start IS-IS as the IGP, enable LDP
on PE 1 and PE 2, and establish an MP-IBGP peer relationship between the PEs:
# Configure PE 1.
<PE1> system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 3.3.3.9 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 3.3.3.9
[PE1] mpls ldp
[PE1-ldp] quit
[PE1] isis 1
[PE1-isis-1] network-entity 10.0000.0000.0000.0004.00
[PE1-isis-1] quit
[PE1] interface loopback 0
[PE1-LoopBack0] isis enable 1
[PE1-LoopBack0] quit
[PE1] interface vlan-interface 12
[PE1-Vlan-interface12] ip address 30.1.1.1 24
[PE1-Vlan-interface12] isis enable 1
[PE1-Vlan-interface12] mpls enable
[PE1-Vlan-interface12] mpls ldp enable
[PE1-Vlan-interface12] mpls ldp transport-address interface
[PE1-Vlan-interface12] quit
[PE1] bgp 100
[PE1-bgp-default] peer 4.4.4.9 as-number 100
[PE1-bgp-default] peer 4.4.4.9 connect-interface loopback 0
[PE1-bgp-default] address-family vpnv4
[PE1-bgp-default-vpnv4] peer 4.4.4.9 enable
[PE1-bgp-default-vpnv4] quit
Loop0
Vlan-int12
PE 1
Vlan-int11
AS 100
Vlan-int11
CE 1
Vlan-int12
Loop0
CE 3
Loop0
Provider carrier
Vlan-int12
Vlan-int11
Vlan-int11
CE 2
Loop0
MP-IBGP
341
PE 2
AS 100
Customer carrier
Vlan-int12
Vlan-int12
Vlan-int11
Vlan-int11
CE 4
AS 65420
PE 4